TP-Link Festa FS352GP 52-Port Gigabit Smart Switch with 48-Port PoE+

TP-Link 52-Port Gigabit Smart Switch with 48-Port PoE+ (Festa FS352GP) - 3 Years Local Warranty

The Festa FS352GP is a 52-port rack switch built for a floor of PoE devices: 48 Gigabit PoE+ ports sharing a 384 W budget, four Gigabit SFP slots for uplinks, and cloud management through the Festa Cloud-Based Controller. It is the largest switch in TP-Link's Festa range and the one to specify when a single cabinet has to power an entire building's cameras, access points and phones.

48 PoE+ Ports Sharing a 384 W Budget

All 48 RJ45 ports are 802.3at PoE+ and 802.3af PoE compliant and each can deliver up to 30 W, drawing on a total budget of 384 W. That budget is what decides a real deployment: 384 W comfortably carries a full complement of IP cameras or door controllers at 6–15 W each, while a floor of 25–30 W Wi-Fi 6 access points will use it up well before all 48 ports are populated. TP-Link notes its PoE budget figures come from laboratory testing and are not guaranteed, varying with the connected devices and the environment.

104 Gbps of Switching Capacity for a Fully Loaded Chassis

The FS352GP is rated at 104 Gbps switching capacity and 77.38 Mpps packet forwarding, which is non-blocking across all 52 interfaces. A 16 K MAC address table and 12 Mbit packet buffer let it sit at the centre of a busy floor without dropping frames during bursts, and 9 KB jumbo frame support keeps storage and backup traffic efficient. This is the headroom that separates a core-of-floor switch from a wiring-closet aggregation box.

Four Gigabit SFP Slots for Fibre or Long Uplinks

Four Gigabit SFP slots sit alongside the copper ports for uplinks to a core switch or a run between buildings where copper cannot reach. Because they are shared across the same switching fabric, an SFP uplink carries the same wire-rate performance as the RJ45 ports. TP-Link publishes these as Gigabit SFP slots on this model — check the optics you order match that rate rather than assuming 10G compatibility.

L2+ Routing, VLANs and ACLs Without a Separate Router

The FS352GP is an L2+ switch: it supports 16 IPv4/IPv6 IP interfaces and 32 static routes, so inter-VLAN traffic can be routed on the switch itself rather than hair-pinning through a gateway. Alongside that it carries a DHCP server, DHCP relay and L2 relay, spanning tree, loopback detection, 802.1ab LLDP/LLDP-MED for voice and AP discovery, IGMP snooping, rate limiting, storm control and port isolation, plus a full combined and IPv6 access control list.

Zero-Touch Provisioning Across Multiple Sites

Adopted into the Festa Cloud-Based Controller, the switch provisions itself: plug it in on site, and configuration, firmware and policy arrive from the cloud. Festa's management set covers auto topology, multi-site management, batch firmware upgrading, batch configuration, integrated troubleshooting tools, network status monitoring and alerting. For an installer running several premises that is the difference between one visit per site and one console for all of them.

Rack Mountable, Three Fans, Physical Lock Point

The FS352GP is a 1U rack-mount unit measuring 440 x 330 x 44 mm with three fans and a Kensington-style physical security lock point, and it runs on 100–240 V AC at 50/60 Hz — correct for Singapore mains without an adapter. Operating temperature is 0–50 °C, wider than the fanless models in the range, which matters in a cabinet with limited ventilation. The box includes the power cord, rackmount kit and silicon feet.

Ideal For

Singapore offices, schools, hotels, warehouses and MSPs powering a full floor of IP cameras, access points, door controllers or VoIP phones from one cabinet, and installers who want per-site switches they can provision and monitor centrally. Supplied by SourceIT with local Singapore warranty, GST invoice and project pricing on request.